DMC TSC-30/IC - Manual (Page 7)

Document No. DER-S0098A 6 Version 1.3 ©2012 DMC Co., Ltd.
TSC-30/IC Product Specification
40 PANEL_THOb2 I/O Touch screen control pin. Used only in 5-wire mode. In 4-wire/8-wire mode, opened.
41 PANEL_THOb1 I/O Touch screen control pin. Used only in 5-wire mode. In 4-wire /8-wire mode, opened.
42 PANEL_THOa I/O Pen down detection pin.
43 PANEL_THI I In power-save mode, start signal input pin by pen down.
44 O Unused pin; Opened.
45 O Unused pin; Opened.
46 O Unused pin; Opened.
47 EEP-DO/JP12 I/O
Vcc is connected.
When using EEPROM, EEPROM DO is connected.
48 EEP-DI/JP11 I/O
When using EEPROM, EEPROM DI is connected.
When not using EEPROM, Vcc is connected via resistance.
49 EEP-CLK/JP10 I/O
When using EEPROM, EEPROM SK is connected.
When not using EEPROM, Vcc is connected via resistance.
50 EEP-CS/JP9 I/O
EEPROM setting pin shared with EEPROM CS signal output pin.
EEPROM is set via resistance and Vcc or GND is connected. (L=Used, H=Not used)
When using EEPROM, EEPROM CS is connected.
51 RxD I In serial mode, data receive pin. In USB mode, Vcc is connected via resistance.
52 TxD O In serial mode, data send pin. In USB mode, opened.
53 O Unused pin; Opened.
54 O Unused pin; Opened.
55 JP1 I GND is connected.
56 JP2 I GND is connected.
57 JP3 I GND is connected.
58 JP4 I Panel ID select pin.
59 JP5 I Panel ID select pin.
60 JP6 I Touch screen mode setting pin; L=4 / 8 wire, H=5-wire
61 JP7 I Touch screen mode setting pin; L=4 / 5 wire, H=8-wire
62 JP8 I
In USB mode, if Vcc is 5V, Vcc is connected via resistance. If Vcc is 3.3V, GND is
connected.
In serial mode, Vcc is connected via resistance or GND is connected.
63 PANEL_AD_YD I Touch Screen YD input pin.
64 PANEL_AD_YU I Touch Screen YU input pin.
*1: Please be careful if you use a external power supply not to exceed the power supply voltage in this
terminal.