Flytec 4030 * - Manual (Page 11)

Flytec
Operating Instructions FLYTEC 4030 10
Altimeter 2 setting mode
The altitude can be set in setting mode in precisely the same way as with altimeter 1.
If altimeter 2 is selected as the absolute altimeter, it is coupled to altimeter 1. Any change in
the display for altimeter 1 is reflected by a corresponding change in the display for altimeter 2
and vice-versa.
Altimeter 2 option mode
In OPTION mode, you can enter the target altitude at the first level using the key and
the key.
Use the key to enter the second level of OPTION mode. There, the GPS-supported func-
tions of the instrument can be switched on or off.
The unit of the ALT 2 display (meters or feet) is determined at the third level. The currently
selected unit flashes in the display. Use the or the key to toggle between the units.
Press key to enter the fourth level of option mode. At this level, you select the operating
mode of altimeter 2. If this is set at absolute altimete, the two indicators ALT 1 and ALT 2 will
flash in the display. If set at relative altimeter, only the indicator ALT 2 will flash.
You return from option mode to run mode by waiting 15 seconds or again pressing the two
keys marked “OPTION” simultaneously.
TIME
SPEED
MEMO
TIME
SPEED
MEMO
CLEAR ALT 2
CLEAR ALT 2
START - STOP
RESET
START - STOP
RESET