LBL Lighting MILO SCH - Manual (Page 2)

2
CORD
CANOPY
Adjust the fixture height (from bottom of the fixture
shade to top of the canopy) by moving the canopy and
strain relief up or down.
When the desired height is achieved, tighten the set
screw on the strain relief.
Mark the cord underneath the strain relief.
3B
2
3
4
3
2
Assemble the Fixture
2A
Feed the canopy, cord, and socket assembly through the
shade. 1
2 Simultaneously pull the cord upward while carefully
lowering the shade onto the stopper.
CORD
SHADE
CANOPY
SOCKET
ASSEMBLY
2B
CORD
SHADE
STOPPER
Install the Fixture
SET SCREW
Loosen the set screw on the strain (Do Not Remove)
relief.
3A
1
3C
Take note of the wire connections and remove the wire
nuts to disconnect the power cord wires from the
ballast wires. 5