LBL Lighting Drop SPCF - Manual (Page 2)

2
Determine the desired fixture height (From the bottom of
glass shade to the top of canopy).
(H)
GLASS SHADE
CANOPY
Feed the cord into the canopy and plastic strain relief.
Adjust the fixture height and mark the cord below the canopy
bushing.
PLASTIC STRAIN RELIEF
CANOPY
CORD
BUSHING
MARKED LINE
PLASTIC STRAIN
RELIEF
1"
Feed the cord inside the canopy so that the marked line is
exposed behind the canopy.
Hold the plastic strain relief 1" above the marked line and
tighten the set screw.
Slide the canopy up against the plastic strain relief and tighten
the M4 set screw snugly on the cap with 2 MM Allen wrench.
CAP
M4 SET
SCREW
2 MM ALLEN
WRENCH
1C
3
1E
1D
1F
4
5
8
6
7
7
8 4
5
7