LBL Lighting Drop SPCF - Manual (Page 3)

3
4"
BALLAST
CAP NUTS
THREADED ROD
WIRE NUT
Leave 6" of the cord behind the canopy for power connections
and cut the excess cord.
From the end of the cord remove 4" of the cord insulation.
Strip 1/4" of the insulation from the wire ends.
Connect one ballast wire to each fixture wire (except ground
wire) with a wire nut.
In accordance with local electrical codes, make sure that the
crossbar and fixture ground wire are grounded.
Connect the white ballast wire to the neutral power line wire
with a wire nut.
Connect the black ballast wire to the hot power line wire with
a wire nut.
Place all wires and wire nut connections properly inside the
canopy housing.
Slide the canopy onto the threaded rods and secure it in place
by tightening the cap nuts completely to the threaded rods.
9
10
11
1G
12
1I
1H
1J
13
14
15
16
17
14
13
11
10
12
12
17
17
15