Install the canopy – LBL Lighting Vera S User Manual
Page 2
2
NOTE:
The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
2
5
2B
CORD
5
Install the Canopy
3A
4"
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife.
.
Make sure not to nick the inner wires
Strip the end of the wires.
7
1
7
2
7
3
3B
Feed the power cord through the middle hole of the
mounting plate and temporarily place it plate in the
canopy.
4
MOUNTING
PLATE
CANOPY
3C
6
7
10
2
5
2
6
Connect the mounting plate and the fixture ground wire
to a suitable ground in accordance with local electrical
codes.
Connect the black fixture wire to the hot power line wire
with a wire nut.
Connect the white fixture wire to the neutral power line
2
7
5
Once the desired look is determined, tighten the set
screw on the strain relief.
Mark the cord underneath the strain relief.
2
6