LBL Lighting Vitre Rectangle S - Manual (Page 3)

6
3
Loosen the set screw in the strain relief.
Pull the power cord through the canopy until it reaches
the length desired and re-tighten the set screw.
Leave 6 inches of cord behind the canopy and cut off
extra cord. 4
3
2
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
3B
Take note of the wire connections and remove the wire
nuts to disconnect the power cord wires from the driver
wires. 1
3A
POWER CORD WIRE DRIVER WIRE
Adjust the Power Cord (optional)
POWER
CORD
4
SET SCREW
STRAIN RELIEF
NOTE: It is recommended that one person hold the
fixture while the electrician connects the power and
installs the canopy.
From the end of the cord, strip the insulation 4" using a
sharp knife. . Make sure not to nick the inner wires
Cut off the extra cord, strip 1/2" off the wire ends, and
reconnect the power cord wires to their original
connections (reversal of 3A). 6
5
3B
5
2 3
1
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
Install the Fixture
4A
1
2
3
6