Shorten the power cord – LBL Lighting Constellation Grande SCF User Manual
Page 3
3
Feed the aircraft cable through the cable clutch in the
canopy.
Pull the aircraft cable up through the canopy to raise
the fixture to the determined length.
Cut off the excess aircraft cable leaving enough for fine
leveling later.
Pull the power cord through the canopy to the desired
length.
2
2
2
NOTE:
The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
Once the desired look is determined, tighten the set
screw on the strain relief.
Mark the cord underneath the strain relief.
2D
CABLE
CLUTCH
AIRCRAFT
CABLE
STRAIN RELIEF
POWER CORD
7
5
SET SCREW
8
2E
CORD
10
5
2
9
2
10
Shorten the Power Cord
2A
Take note of the wire connections and remove the wire nuts
to disconnect the power cord wires from the driver wires.
1
POWER CORD
2B
Loosen
the set screw on the strain relief.
(Do Not Remove)
Remove the crossbar from the canopy by completely
unscrewing the strain relief.
2
STRAIN RELIEF
CROSSBAR
CANOPY
3
2C
#8-32
SCREW
CROSSBAR
Mount the crossbar assembly to the electrical box with
the two provided #8-32 screws.
4
4
4
2
3
6
7
8