Install the fixture – LBL Lighting Derby Rectangular S User Manual
Page 3
3
3B
7
8
6
2
6
2
7
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the black fixture wire to the hot power line wire
with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
2
8
3C
2
9
Place all wire and wire nut connections inside the
canopy.
Align the canopy holes with the crossbar holes. Secure
the canopy in place by tightening the four screws.
2
10
SCREW
SCREW
Install the Fixture
NOTE:
Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
Feed the aircraft cables through the cable clutches in
the canopy.
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired length.
Cut off the excess aircraft cable leaving enough for fine
leveling later.
If necessary loosen the set screw in the strain relief and
feed the power cord from the fixture into the canopy
port.
2
1
2
2
2
3
2
4
SET
SCREW
NOTE:
The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
Once the desired length is determined, tighten the set
screw, leave 6 inches of the power cord behind the
canopy and cut off the extra cord.
2
5
AIRCRAFT
CABLE
AIRCRAFT
CABLE
POWER CORD
STRAIN
RELIEF
CABLE
CLUTCH
CABLE
CLUTCH
1
1
3
3
4
5
3A