LBL Lighting Veneto SP - Manual (Page 2)

2
Temporarily remove the canopy and half ball pivot from the
assembly by unscrewing the pivot from the hub and pulling the
fixture wires through.
Feed the fixture wires through the optional extension stem(s)
and tighten completely to the threaded nipple on the hub.
Feed the fixture wires through the canopy and half ball pivot
and tighten completely to the threaded nipple on the new
extension stem.
Adjust the Fixture Height (Optional)
EXTENSION STEM
THREADED NIPPLE
THREADED NIPPLE
HUB
HALF BALL PIVOT
CANOPY
NOTE: Use a 24" stem for the minimum 34" overall
height.To extend the fixture height to 46", or 58", or 70",
use the additional 12", or 24", or combination of 12" and
24" provided extension stems respectively.The extension
stems are not field cuttable.
Place all wire and wire nut connections inside the
electrical box.
Align the canopy holes with the crossbar holes. Secure
the canopy in place by tightening the four screws with
the provided Allen wrench.
SCREW ALLEN
WRENCH
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the black fixture wire to the hot power line wire
with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Install the Fixture
3A 2A
1
2
3
3B
2
3
1
4
5
3
2
1