Halogen lamp general information, Two tips for prolonging halogen lamp life, Save these instructions – LBL Lighting Veneto SP User Manual

Page 4: Important safety instructions

Advertising
background image

4

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:

– Use this fixture indoors only.

– Do not look directly at the lighted lamp.

– Do not remain in light if skin feels warm.

– Risk of fire: Use only the type of lamp and maximum wattage

indicated in this instruction manual.

– Never cover the halogen lamp with anything other than a LBL

Lighting lamp shield and never place flammable material close to
your fixture.

– Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

– Do not touch the fixture shades or lamp shield while the fixture

is on.These surfaces may be HOT.

Halogen Lamp General Information

– A new halogen lamp may smoke slightly when it is used for the

first time.This is perfectly normal; the protective coating is simply
being vaporized.

Two Tips For Prolonging Halogen
Lamp Life

– First avoid touching the lamp with bare hands during installation.

Any contaminant, even the oil from your hands can deteriorate

the lamp. Rubbing alcohol can be used to remove any
contaminant.

– Second, do not run the lamps at full power when you do not

need to. However, if dimming the fixture for an extended period
of time, occasionally bring the light up to full brightness for a few
minutes to complete the halogen cycle.

HUB

CABLE
CLUTCH

AIRCRAFT
CABLE

GLASS

Feed the aircraft cables through the cable clutches in
the hub.

Pull the aircraft cable up behind the hub to raise the
glass. Make sure that the glass is at least 3.5” away
from the lamp, but high enough to cover the lamp.

To lower the glass shade, push the cable clutch in and
pull the aircraft cable down.

When the glass is in the desired position, trim the excess
aircraft cable behind the hub.

NOTE:

To replace the lamps, simply reach the lamp

from top of the glass shade. The canopy is equipped
with a max 45 tilt capability which may assist in

°

lamp replacement.
DO NOT REMOVE THE GLASS.

NOTE:

Make sure to support the glass shade while

adjusting the aircraft cables. An assistant is
recommended to complete these steps.

5C

7

8

9

10

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, IL 60077

800.323.3226 - 847.626.6300

www.lbllighting.com

© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.

A Generation Brands Company

Advertising