Install the fixture – LBL Lighting Veneto Grande SPCF User Manual
Page 3
3
2C
From outside of the glass shade, insert the cap screw through
one glass shade hole.
Place the second plastic washer onto the cap screw and finger
tighten the knurled nut to secure the cap screw in place.
Screw the cable bushing completely to the cap screw.
Repeat steps 4 through 6 for the remaining glass shade holes.
4
5
6
GLASS SHADE
CAP SCREW
4
7
8
CAUTION:
These set screws must be very tight to secure
the glass in place. Failure to do so may cause the glass shade
to fall.
Install the Fixture
3A
Mount the crossbar to the electrical box with the provided
two #8-32 screws.
1
#8-32 SCREW
CROSSBAR
1
1
For a nice and neat look, trim off excess aircraft cables coming
out of the strain reliefs.
KNURLED NUT
PLASTIC WASHER
CABLE BUSHING
6
5
9
10
11
For each strain relief, loosen (Do Not Remove) the M3 set
screws with the provided 1.5MM Allen wrench.
Adjust the aircraft cable so that there is enough space between
the bottom of the lamps and the inside glass shade.
Adjust the marked aircraft cables in the strain relief and make
sure that the strain relief sits against the hub; tighten the two
M3 set screws with the 1.5MM Allen wrench.
1.5MM ALLEN WRENCH
M3 SET
SCREW
AIRCRAFT
CABLE
2D
STRAIN
RELIEF
HUB
8
9
10
3B
Connect the fixture bare wire and the crossbar green wire to
the ground in accordance with local electrical codes.
Connect the fixture black wire to the hot power line wire with
a wire nut.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
2
3
4
2
3
4
NOTE:
To ease the installation, it is recommended to
remove the glass shade by unscrewing the cable bushings
(refer to drawing 2C).