LBL Lighting Veneto Venti SPCF - Manual (Page 2)

STEM ASSEMBLY
2
Adjust the Fixture Height (Optional)
NOTE: Install a stem extension or a combination of the
stem extensions (above the cable hub) to create the
desired length.The extension stems are not field
cuttable.
NOTE: If height extention stems are not being added,
skip this step. NOTE: If height extension stems have been added,
skip this step.
Assemble the Fixture
Feed the fixture wires from the socket assembly through the
stem assembly and tighten it completely to the socket
assembly.
Leaving enough wire to make power connections, cut off the
excess wire and sleeve.
WIRE SLEEVE
FIXTURE WIRES
Temporarily remove the canopy and half ball pivot from the
assembly by unscrewing the pivot from the stem with the hub.
Feed the fixture wires and wire sleeve from the socket
assembly through the stem with the cable hub and tighten it
completely to the socket assembly.
Feed the fixture wires and wire sleeve from the through the
optional extension stem(s) and tighten it completely to the
stem with the hub.
Feed the fixture wires and wire sleeve through the canopy and
half ball pivot, then tighten completely to the new extension
stem.
Leaving enough wire to make power connections, cut off the
excess wire and wire sleeve.
EXTENSION STEM
CABLE HUB
HALF BALL PIVOT
CANOPY
STEM
SOCKET
ASSEMBLY
FIXTURE WIRES
WIRE SLEEVE
2A
1
2
3
4
5
2
1
3A
2
1
3
2
4
5