LBL Lighting Clifton - Manual (Page 2)

2
Adjust the Canopy
Note : Depending on the size of the shade and the
desired distance of the shade from the wall,
Adjustments of the canopy length can be made
using this section.
If needed, adjust the canopy arm’s length by loosening
the two set screws on the top of the canopy arm, pull
the arm out to the desired position, and secure it in
place by re-tightening the set screws.
CANOPY ARM
SET SCREW
ALLEN WRENCH
1 1
1A
2A
1
Note : It is important to plan out the desired height
of the pendant along with the desired distance from
the wall before shortening the cable.
Install the Fixture
1A
3A
STRAIN RELIEF
SET SCREW
CORD
1
2
Note: If the fixture has a cord with a cloth cover,
taping down the frayed end of the cloth may assist
in feeding it through the strain relief.
Loosen (Do Not Remove) the set screw on the strain relief.
Feed the cord through the primary strain relief and the
canopy.
Adjust the fixture height (from bottom of the fixture shade
to the canopy arm) by feeding the fixture cord through the
canopy and strain relief.
When the desired height is achieved, tighten the set screw
on the strain relief.
3
4
5
6
7
1A
3B
TAB
5
6
7 7
Install the secondary strain relief by first feeding the
power cord through it.
Snap the strain relief tab into place.
Pull the cord to take up the slack and fit the rest of the
cord in the strain relief’s openings.
4"
1A
3C
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. . Make sure not to nick the inner wires
Strip the end of the wires.
8
9
10