LBL Lighting Mia W - Manual (Page 2)

2
Install the Mounting Plate
Make sure the two inner threaded holes on the mounting
plate are positioned vertically.
Line up two mounting plate slots with the two electrical box
holes.
Level the mounting plate vertically and secure it to the
electrical box with the two short #8-32 screws provided.
NOTE: For vertical installation the inner threaded holes
must be in horizontal position.
Install the Backplate
Line up the two backplate slots with the two mounting plate
inner threaded holes.
Level the backplate horizontally and secure it to the electrical
box with the two long #8-32 screws provided.
Connect the Power
Turn the power to the electrical box off.
Make sure that the mounting plate is grounded in accordance
with local electrical codes.
Connect the black fixture wire to the hot power line wire with
a wire nut.
Connect the white fixture wire to the neutral power line wire
with a wire nut.
Properly place all wires into the electrical box.
Install the Lamp
SHORT #8-32
SCREW
MOUNTING PLATE
INNER THREADED HOLE
INNER THREADED HOLE
LONG #8-32 SCREW
C AUTION:To reduce the risk of a burn or electric
shock during relamping, disconnect the power to the
fixture by turning the wall switch off.
Use 120 Volt, Watt Type T4, MAX 60
E11 Base Mini Candelabra Halogen Lamp.
NOTE: Use only your fingers and a soft cloth to replace
the lamp.
Screw the lamp into the socket.
4
5
1
2A
3
1
1
2
3
1
3
2
3
1
1
2
3A
3
4
1
4A
5A
2
2