LBL Lighting Mia W - Manual (Page 3)

3
Install the Glass Shade
Replace the glass shade into backplate.
Tighten the two thumb screws on one side of the backplate.
THUMB SCREW THUMB SCREW
1
GLASS SHADE
BACKPLATE
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:
– Use this fixture indoors only.
– Do not look directly at the lighted lamp.
– Do not remain in light if skin feels warm.
– Risk of fire: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
– Never cover the halogen lamp with anything other than a
Tech Lighting lamp shield and never place flammable
material close to your fixture.
– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
– Do not touch the fixture shades or lamp shield while the
fixture is on.These surfaces may be HOT.
Halogen Lamp General Information
– A new halogen lamp may smoke slightly when it is used for
the first time.This is perfectly normal; the protective
coating is simply being vaporized.
Two Tips For Prolonging Halogen
Lamp Life
– First avoid touching the lamp with bare hands during
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.
– Second, do not run the lamps at full power when you do
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.
NOTE: Do not over tighten the thumb screws which may
cause the glass shade to break.
6A
1
1
2 2
6B
2