LBL Lighting LED Illum MO Surf Mag Xfmr 150w 120v/12v - Manual (Page 3)

Install the LED Transformer
CROSSBAR
#8-32 FLAT
HEAD SCREW
Remove the two #8-32 flat head screws to remove the
crossbar.
#8-32
SCREW
CROSSBAR
Mount the crossbar to the electrical box with the provided
two #8-32 screws.
CAUTION: Turn the power to electrical box off!
3
INNER WIRE
Feed the power feed cord through power feed housing and the
metal tube (included in the package) respectively. Slide the
power feed housing and the metal tube down the cord.
From end of the power feed cord, using a sharp cutter, cut a
slot for 3/4" on the outer wrapped wire.
Unwrap the cut portion of the outer wrapped wire and cut
around it evenly to remove it from the inner wire.
POWER FEED
HOUSING
METAL TUBE
3/4"
OUTER WRAPPED WIRE
INNER WIRE
CONTACT POST
INSULATED BUSHING
WIRE CAP
Strip exactly 1/4" of the inner wire. If the wire becomes frayed,
gently twist it between the thumb and forefinger.
Slide the insulated bushing on to the cord against the outer
wrapped wire.
Slide the new wire cap (included in the package) completely
onto the stripped portion of the inner wire.
Place the contact post completely onto the wire cap.
OUTER WRAPPED WIRE
INSULATED BUSHING
1.5MM ALLEN WRENCH
M3 SET
SCREW
Tighten the M3 set screw on the contact post with the 1.5MM
Allen wrench.
Slide the insulated bushing completely onto the contact post.
Pull the outer wrapped and metal bushing against the insulated
bushing.
METAL TUBE
CONTACT
POST
M3 SET SCREW
POWER FEED
HOUSING 1.5MM ALLEN WRENCH
METAL TUBE
Slide the power feed housing completely against the insulated
bushing. Make sure that the set screws are not inline with the
metal tube slot.
Tighten the two M3 set screws with the 1.5MM Allen wrench.
1A 1F
1A 1G
11
14
12
15
16
1A 1H
18
19
20
13
17
21
22
1A 1I
11
13
21
22
15
12
14 16
17
20
18
19
1A 2A
1A 2B
1
2
1
2
1
2