LBL Lighting MO Surf Elec Xfmr 60w 277v/12v LED - Manual (Page 2)

2
2A
1
2
6 3
Adjust the Height
6 4
Install the Mounting Plate
1
1A
SCREW
Separate the back plate from the transformer housing by
unscrewing and removing the screws.
MOUNTING
PLATE
MOUNTING PLATE
#8-32 SCREW #8-32 SCREW
1B
Mount the backplate to the electrical box with the two #8-32
round head screws. 2
ELECTRICAL
BOX
STRAIN RELIEF
POWER FEED WIRES
Take note of the wire connections and remove the
transformer wire nuts on the power feed wires.
Loosen the set screws on the strain relief and pull out
the power feed wires.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the transformer
housing for wire connections and tighten the set
screws.
Strip 1/2" off the wire ends and reconnect the power
feed wires to their original connections.
6 5
6 6
TRANSFORMER
HOUSING
SET SCREW
TRANSFORMER
HOUSING
1
1