Weems and Plath Endurance II 135 Barometer/Thermometer - Manual (Page 4)

II. Installation Instructions
All instruments can be mounted in one of two ways:
1) Instruments can be screwed in place on a wall or boat bulkhead using the
enclosed screws and mounting template.
a. Poke holes in the indicated drill holes on the paper template
diagram.
b.
Place the template on the wall or bulkhead in the place you
want to install the instrument. Tape it to wall if helpful.
c. Use a bubble level along the horizontal dotted line or hang a
plumb line along the vertical dotted line to be sure placement is level.
d. Once correctly positioned, mark the wall through the template
holes with a pencil or screwdriver.
e. Remove the paper from wall and drill pilot holes with a 1/8 inch
or 3.5mm drill bit.
f. Place the black rubber vibration isolation gasket between the
back of the instrument and the boat bulkhead to absorb
vibrations. This mounting gasket also ensures that the
wall/bulkhead is protected from marks.
g. Secure the instrument using a philips head screwdriver and the
stainless steel screws provided.
2) Instrument can be mounted on a wall using the keyhole slot located
on the backside of the instrument. Secure one of the provided screws
partially into the wall in desired location. Place keyhole slot over screw
to hang. (Not recommended for boat mounting.)
3