Weems and Plath Electronic Barometer - Manual (Page 13)

13
This function allows the rapid visualization of information and is particularly practical for
watch changes.
Initial Memorization of Information:
Press the
mem. button; MEM. flashes on the upper screen. The Electronic Barometer asks if
you wish to memorize the flashes in front of YES or NO.
Use the arrows + - to select YES:
• If YES: the air pressure value is recorded with the corresponding date
and time.
• If NO: the dialogue zone becomes a chart zone and MEM disappears from the upper
screen.
Reminder about Memorized Values:
Press the
mem. button. Select RECALL by using the + - buttons.
Press
oK
; the recorded values are displayed as follows:
• A cursor appears on the display.
• The cursor corresponds to the moment that the data was recorded
into the device’s memory. The air pressure and time values appear on
the LCD at the top.
A situation that has been recorded into the device’s memory is automatically erased
after 48 hours. Press
oK
to display the chart with the vertical marker.
Please note, the ZOOM mode should allow the marker’s display.
New Memorization:
Press the
mem. button. Select CANCEL, confirm with the
oK
button. Use this procedure for
the initial memorization.
MOON PHASE
The Moon icon on upper left corner rotates continuously (showing function), when it stops
(for about 3 seconds) it displays current moon phase.
ZOOM FUNCTION
Zoom
The full chart screen displays the ZOOM corresponding to the air pressure on 2
coordinates using dotted lines.
The horizontal axis corresponds to time. One dash or one space corresponds
to 1 hour, except in the 48 hr zoom where these symbols correspond
to 2 hours.