Weems and Plath Electronic Barometer - Manual (Page 8)

8
Navigation Buttons:
> mode button
Used for the following settings:
- Time: summer, winter, dual
- alarm
- Buzzer: volume and stop settings
- reset
> mem button
Used for entering data
into the system’s memory
or as a "return" button
> hIsT + button
Used to display records
or to increase values during setup
> Zoom – button
Used to select the zone to Zoom
or to decrease values during setup
> alr. Button oK
Used to activate the alarm
or as an "oK" button to validate
setup information
INSTALLATION
We strongly recommend that you fi rmly attach the holder to the wall and not simply
place the Electronic Barometer on a fl at surface.
Positioning the Electronic Barometer:
• Remove the screws which are used to fasten the device to the wall mount.
• Gently lift the tabs on the bottom of the mount.
• The 2 holes in the center of the mount are used to insert 2 screws into
one of the boat’s walls.
• Fasten the holder to the wall.
• Place the barometer into the holder.
• Replace and tighten the retaining screws on top of unit, avoid over-tightening.
The installation of the batteries must be done before placing the device into the
holder