2 enclosure mounting to tripod leg, Enclosure mounting to tripod leg, 9. enclosure with the –mm bracket – Campbell Scientific CM106BK Tripod Kit User Manual
Page 21
CM106BK Tripod Kit
Route the 14 AWG wire from the grounding lug on the bottom side of the
enclosure to the grounding lug on the base of the tripod (FIGURE 2-6). Strip
1/2 in. (12.7 mm) of insulation from each end of the wire. Insert wire ends into
the grounding lugs and tighten.
FIGURE 2-9. Enclosure with the –MM Bracket
2.8.2 Enclosure Mounting to Tripod Leg
An enclosure ordered with the –LM bracket has a bracket on each side of the
enclosure, and a U-bolt bracket for securing the enclosure to a tripod leg.
Attach an enclosure with the –LM mounting bracket to the tripod base as
follows:
Slide the keyhole notch in upper corner of the –LM bracket over the hook
located on the tripod base as shown in FIGURE 2-10, and engage the notch in
the lower corner of the –LM bracket with the enclosure tab.
Remove the washers, nuts, and U-bolt from the U-bolt bracket. Install the
bracket as shown in FIGURE 2-10 (bottom) with the U-bolt capturing the
tripod leg. Tighten the nuts on the U-bolt until the lock washers are
compressed.
13