Campbell Scientific CM106K Tripod - Manual (Page 20)

CM106K Tripod
2.7 Crossarm Attachment
Attach the CM202 (2 ft, 0.6m), CM204 (4 ft, 1.2m), or CM206 (6 ft, 1.8m)
crossarm to the tripod mast as shown in Figure 2-8. For wind sensors, the
crossarm should be approximately 103 inches above the ground. Typically the
crossarm is oriented East/West for wind sensors, North/South for
pyranometers.
CM200 Series
Crossarm
Tripod Mast
FIGURE 2-8. CM204 Crossarm
2.8 Enclosure Attachment
The ENC 10/12, ENC 12/14, ENC 14/16, and ENC 16/18 enclosures can be
ordered with mounting brackets for the CM106K tripod. All enclosure models
can be mounted to the tripod mast (above the legs) with the –MM Mast Mount
bracket option. All enclosure models except the ENC 16/18 can be mounted to
the tripod base and leg with the –LM Leg Mount bracket option.
2.8.1 Enclosure Mounting to Tripod Mast
An enclosure ordered with the –MM bracket has a three-piece top and bottom
brackets with a U-bolt for each bracket.
Attach an enclosure with the –MM mounting bracket to the tripod mast as
follows:
Remove the U-bolts washers and nuts from the brackets.
Position the enclosure against the tripod’s mast (North side recommended).
Install the U-bolts, flat washers, lock washers, and nuts. Tighten the nuts until
the lock washers are compressed.
14