Campbell Scientific NL100 Network Link Interface - Manual (Page 21)

NL100/105 Network Link Interface
By default the address is 0. To enable security, enter a value between 1 and
65535.
2.4.4 Defaults
The Defaults option displays the factory default settings for the different
telecommunication options. Following the display is a prompt to Save or
Cancel. If Save is selected, the NL100/105 will be reset to the factory defaults.
If Cancel is chosen, the current settings will remain in effect and the user will
be returned to the main menu prompt. The default settings are as follows:
TLink config: [disabled]
RS485 config: [disabled]
CS I/O config: [Tcp Ser]
CS I/O SdcAddr/bps: [9600]
CS I/O serial server port number [6783]
RS-232 config: [ConfMon]
EtherNet 10BASE-T: [enabled]
10BASE-T port IP address: [192.168.111.222]
10BASE-T port network mask: [255.255.0.0]
IP address of the default gateway: [0.0.0.0]
PakBus Address of the NL100/105: [678]
Clock source address: [0]
Central Routers: [0]
PakBus/Tcp server config: [disabled]
PakBus/Tcp client config: [disabled]
MODBUS/TCP gateway config: [disabled]
Telnet IP port number: [23]
Telnet session password: [nl100]
DevConfig security code: [0]
This option is different from the Reset menu item. The Default menu item
resets the NL100/105 back to the factory defaults. Reset reboots the device
using the last-saved configuration.
After the NL100/105 reboots, it may take a few moments to reestablish
communication. Press enter a few times until the NL100/105 status line is
returned.
17