Campbell Scientific NL115 Ethernet Interface and CompactFlash Module - Manual (Page 19)

NL115 Ethernet and CompactFlash ® Module
FIGURE 7-3. FTP CRD directory
In order to use FTP, the datalogger’s FTP User Name and FTP Password must
be set. This is done using Device Configuration Utility.
Step 1: Configure Datalogger
a. Connect serial cable from PC COM port to datalogger RS-232 port.
b. Open Campbell Scientific’s Device Configuration Utility. Select the
device type of the datalogger (CR1000 or CR3000), the appropriate serial
port and baud rate. Connect to the datalogger.
e. Under the Net Services tab, verify that FTP Enabled is checked. Input the
FTP User Name and FTP Password.
f. Press the Apply button to save the changes and then close the Device
Configuration Utility.
Using “anonymous” as the user name with no password allows
FTP access without inputting a user name or password.
Step 2: Access File System
a. The datalogger must be set up for Ethernet communications as explained
in Sections 4.1, Physical Setup, and 4.2, Communicating via Ethernet
(Step 1 only).
NOTE
13