Campbell Scientific NL115 Ethernet Interface and CompactFlash Module - Manual (Page 9)

NL115 Ethernet and CompactFlash ® Module
4.2 Communicating via Ethernet
4.2.1 Step 1: Configure Datalogger
a. Connect serial cable from PC COM port to the datalogger RS-232 port.
b. Open Campbell Scientific’s Device Configuration Utility. Select the
device type of the datalogger (CR1000 or CR3000), the appropriate serial
port, and baud rate. Connect to the datalogger.
c. Under the TCP/IP tab, input the IP Address, Subnet Mask, and IP
gateway. These values should be provided by your network
administrator.
FIGURE 4-2. DevConfig setup
d. Press the Apply button to save the changes and then close the Device
Configuration Utility.
A temporary IP address may be obtained from a DHCP server.
For more information, see Section 7.1.8, DHCP.
The NL115 must be connected to the datalogger before
configuring the datalogger with the Device Configuration Utility.
If it is not connected, the TCP/IP settings will not be displayed.
NOTE
NOTE
3