Campbell Scientific PConnect Software for Palm™ OS PDAs - Manual (Page 16)

PConnect for the Palm Handheld
NOTE
IR communication is not available for the CR200 Series
dataloggers.
The communications protocol for RF4xx radios must be set to Transparent.
PConnectCE will not be able to connect reliably with the dataloggers if
PakBus Aware or PakBus Node is selected. When the RF400 is selected, an
RF Net Address and an RF Radio Address must be entered. These two settings
must reflect the settings in the remote RF400 radio or in the CR205. PConnect
will temporarily set the RF base modem's addresses to the addresses specified,
and then return them to the previous values after you disconnect.
10