Campbell Scientific Sentek EnviroSCAN Access Tube Installation Guide - Manual (Page 27)

Installing EnviroSCAN, EnviroSM ART & Diviner 2000 access tubes
© Sent ek Pt y Lt d Page 24
16. Auger ahead of the access tube by approximately 10 – 20 cm (4 – 8 inches). Alternate
between augering and hammering until the dolly resting on top of the access tube nearly
touches the top of the tripod.
17. Insert the yellow Nylon dolly (which has the same diameter as the access tube) into the
access tube and continue hammering and augering until the mark on the dolly is level with
the top of the tripod.
Note: Installing the access tube to this depth will enable the base of the
top cap to sit flush with the ground. This will position the middle of the
first sensor at 10 cm below the ground surface. Sometimes it may be
desirable to position the first sensor 5 cm below the ground surface. If
this is the case, only hammer in the yellow nylon dolly until the mark on
the dolly is 5 cm above the top of the tripod.
18. Auger out the remaining soil from inside the access tube.
19. Remove the tripod pins by inserting the Tommy bars into the holes of the tripod pins and
pulling them upwards with a twisting motion.