Campbell Scientific Wireless Sensor Network (CWB100, CWS220, and CWS900) - Manual (Page 26)

Wireless Sensor Network
3.2.3.1 Simple WSN Example
In this example, a CWB100 base station communicates with a CWS655 and a
CWS900 with a 109-L-CWS temperature sensor attached. Both sensors are
within radio range of the base so no repeaters are necessary.
Although station names and measurement names may be customized in
Wireless Sensor Planner, the fastest way to configure the network is to use the
default names provided. When using default names, the network is configured
simply by entering the base station address and choosing a measurement
configuration for each CWS900 in the network. In this Quick Start example,
default names will be used.
Placing Devices on the Drawing Canvas
Begin by placing a CWB100, a CWS655 and a CWS900 on the Drawing
Canvas. Select CWB100 from the Device Palette then click anywhere on the
Drawing Canvas to place it there. Next select CWS655 from the Device
Palette and select the Drawing Canvas. Finally, select CWS900 from the
Device Palette and select the Drawing Canvas. The icons on the Drawing
Canvas may be repositioned by selecting the icon and dragging it to a different
part of the canvas.
Link Tool
18