Campbell Scientific Wireless Sensor Network (CWB100, CWS220, and CWS900) - Manual (Page 31)

Wireless Sensor Network
3.3.2 Configuring the CWS655
To configure the CWS655 Water Content Reflectometer, first connect the
A205 to the type B USB connector on the 17648 cable. Remove the battery
door on the CWS655 and locate the four-pin connector near the top of the
sensor. Connect the A205 to the sensor at the four-pin connector. The A205
label should be facing toward the CWS655 antenna.
Select the Program settings for CWS655_1:CWS655 item in the Configure
Devices list, then select
Click Here .
When the Setup Dialog window for configuring the CWS655 opens, verify that
the Serial Port matches the port number where the A205 is connected and click
Connect. Press the Setup button on the back of the CWS655. Settings will be
transferred and applied to the CWS655. In the Settings have Been Applied
window, options are available for saving the settings to a XML file, printing
the settings, and comparing the settings to another XML file. When finished
with these actions, click OK.
The Setup button must be pressed to enable communications
between the wireless sensor and computer. NOTE
23