Wesley shipboard - Manual (Page 14)

14
SHIPBOARD DEADMAN BRAKE
CABLE REMOVAL AND ADJUSTMENT
1. Remove both DM-06 and DM-12 pivot pulls
2. Loosen associated set screws in the pivot pulls.
3. Remove DM-08 short and long bolts followed by the brake cable housing and the brake ca-
ble.
4. Replace the DM-21 brake cable housing and DM-22 brake cable. Insert the DM-22 brake
cable through both the DM-08 short and long bolts. Install the DM-08 long bolt into han-
dle tube and DM-08 short bolt in the DM-01 spindle stop.
5. Replace both the DM-06 and DM-12 onto DM-22 brake cable. Insert the brake cable into
the bottom of the 3/32 hole. Tighten associated set screws.
6. To set the brake release, the DM-10 brake handle assembly Must be in Contact with the
Steer Handle when the brake is fully disengaged.
7. If the handle is not making contact with the steer handle, proceed as follows: Turn the DM-
08 long & short bolts in a clockwise rotation until the DM-10 brake handle makes contact
with the steering handle.
8. If the brake is not releasing, proceed as follows: Turn DM-08 long & short bolts in counter
clockwise rotation until the brake releases with DM-10 brake handle making contact with
the steering handle.