Wesley shipboard User Manual
Page 15
15
DEADMAN BRAKE ASSEMBLY &
FRAME MAINTENANCE INSTRUCTIONS
1. Inspect visually that all pins are in place.
2. Check tightness of all pivot screws (Item # 27, 28, Drawing 3)
3. Wipe down – removing excess grease and foreign materials
4. Oil any visible rust or corrosion spots.
5. One drop of moly-disulfide bearing grease on each projecting clapper plate stop pins, visi-
ble through holes in the Steer Wheel.
6. One drop of non-detergent SAE 30 oil on the top end of Item # 26 (Drawing 5) on handle.
This will migrate down into Item # 8, lubricating both Item # 21 and Item # 22.
7. One drop of non-detergent SAE 30 oil applied to the following locations:
8. With pump handle turned 90 degrees, reach inside of wheels and apply oil to Clapper Plate
Pin, Item #32 (Drawing 3), one inside of each wheel.
9. Apply grease to ¼” fitting with Corrosion Control ( Mystic Mfg. P/N JT6-HI-T-P) type
grease in the following locations:
Drawing #
Item
Part #
Description
1
18
B1-13 SS
Release Plunger, Stainless Steel
1
25
B1-26 10M SS
Lift Ram 10M, Stainless Steel
1
33
B1-38B
Restrictor O-ring
1
17
B1-15.5
Pump Piston Seal
1
16
B1-17.5 SS
Pump Piston, Stainless Steel
5
8
DM-8
Housing Clamp, Adjustable
3
28
DM-28
Link Shoulder Screw
5
27
DM-27
Pivot Shoulder Screw
5
26
DM-26
Jam Nut
5
15
DM-15
Cable Tube, Welded to Handle
Part #
Description
# of Fittings
DM-09
Steer Wheel Assembly
2
B3-01 R7 Spec
Right Bellcrank
2
B3-01 L7 Spec
Left Bellcrank
2
B4-01T GF
Load Wheel Fork, 2
3