Acer Altos 1100 Series - Manual (Page 73)

Chapter 2 - BIOS Utility 2-31
PnP/PCI System Configuration Page 2/2
PCI IRQ Sharing ............... [No]
VGA Palette Snoop .............. [Disabled]
Graphics Aperture Size ......... [ 64 ] MB
Plug and Play OS ............... [No]
Reset Resource Assignments ..... [No]
↑↓
= Move Highlight Bar,
→ ←
= Change Setting, F1 = Help
PCI IRQ Setting
This parameter allows for Auto or Manual configuration of PCI devices. If you
use plug-and-play (PnP) devices, set this parameter to Auto. The system then
automatically assigns IRQs to PnP devices. If your PCI device is not a PnP, you
can manually assign the interrupt for each device. Refer to your PCI card manual
for more information. The default setting is Auto.
When the PCI IRQ Setting is set to Auto, all
the IRQ setting fields become gray and non-
configurable.
PCI Slots
These parameters allow you to specify the appropriate interrupt for each of the
PCI devices. You can assign IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10, IRQ11,
IRQ12, IRQ14, or IRQ15 to the slots.