Alliance Laundry Systems W001C - Manual (Page 10)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
39239 8
High Standpipe Installation:
Place the hose into the standpipe. Remove the beaded
tie-down strap from accessories bag and place around
standpipe and drain hose, approximately 12 inches
(30 cm) down from the top of pipe and tighten strap to
hold hose to standpipe. This will prevent the drain
hose from dislodging from drain receptacle during use.
Figure 7
Low Standpipe Installation:
No. 562P3 Siphon Break Kit is required for this type
of installation. This kit is available (as optional
equipment at extra cost) through an authorized dealer
or parts distributor. Installation instructions are
supplied with the kit.
Figure 8
TLW1962N
1 Drain Hose
2 Standpipe (Standpipes higher than
4 feet [122 cm] are not recommended)
3 Tie-Down Strap
4 Standpipe Adapter
TLW1962N
2
1
3
4
W512I
1 562P3 Siphon Break Kit
2 Standpipe
3 Drain Hose
W512I
3
1
2