Ethernet commands, Using interface ethernet command – ADC SG-1 User Manual

Page 204

Advertising
background image

Appendix B: Redirection Server

June 30, 2006

B-10

SG1-UM-8500-03

Example:

E

THERNET

C

OMMANDS

Using interface Ethernet command

• The Ethernet command is used for configuring the RDS IP address.

• It is located at the “configure terminal” menu.

• The change is affecting immediately.

Usage

interface Ethernet 1 <RDS IP address> <RDS mask> [mode <Ethernet mode>]

Parameter(s)

<RDS IP address>

This is the IP address of the Ethernet interface of the Redirection Server.

<RDS mask>

This is the mask of the Ethernet interface of the Redirection Server.

<Ethernet mode>

This is the Ethernet mode and it is one of the following: Auto, 10H, 10F, 100H, 100F, 1000H(negotiate), 1000F
(negotiate). The default mode is Auto.

Example:

RDSHost>

RDSHost> show system

Up-time: 0 Hours, 38 Minutes, 23 Seconds

CPU usage: 50 %

Average Http hits per minute:8681

Accumulated Http hits on port 80:19993456

Accumulated Http hits on EDS port:39986912

RDSHost>

RDSHost>

RDSHost> config termin <cr>

RDSHost(config)> interface Ethernet 1 192.168.2.5 255.255.255.0 <cr>

RDSHost(config)>

Advertising