ADC SG-1 - Manual (Page 25)

June 30, 2006 Chapter 2: Installation
SG1-UM-8500-03 2-5
Installing Blank Faceplates
Use the blank faceplate identified in the “Blank Faceplate Requirement” on page 1-6 .
S ERIAL C ABLE
!
IMPORTANT Install blank faceplates in the SG-1 chassis to cover unused slots. Unused slots must be covered
to prevent personnel contact with back panel connectors under power and to maintain proper
airflow within the chassis.
Step Action
1 Slide the blank faceplate into the empty slot. Ensure the retaining latches are lifted.
2 Push the blank faceplate in until the retaining latches touch the SG-1 chassis.
3 Gently close the retaining latches until they snap into place.
4 Tighten the captive screw on the top and bottom retaining latches.