NewAir Portable Dishwasher ADW-2600W - Manual (Page 12)

Changing Wash Cycles
If the dishwasher has only been running for a short period of time, you can change the wash
cycle. However, if the machine has run long enough that the detergent has already been
released, it is also possible that the wash water has already been drained. In this case, you will
need to refill the detergent dispenser and then choose the appropriate cycle. See section
“Using Detergent.”
Press the Start/Reset button and hold for three seconds. This will put the dishwasher into
standby mode and allow you to change your wash cycle to the appropriate program. After
choosing the appropriate wash cycle, press the Start/Reset button one more time. The
dishwasher will resume washing in approximately 10 seconds.
Note: Opening the door while the dishwasher is running will cause the dishwasher to
momentarily pause. To start the wash again, close the door and push the Start/Reset button.
The dishwasher will resume washing in approximately 10 seconds.
Indicator Lights:
A. All program lights off: Stand-by
B. One program light is illuminated Paused
C. One program light is blinking Running
Note: If you open the door while the dishwasher is running, the dishwasher will pause. After
closing the door and pushing Start/Reset, the dishwasher will resume in approximately 10
seconds.
Adding a Dish
You can add an additional dish at any time before the detergent has been released from the
detergent dispenser.
1. Press the Start/Reset button.
2. Open the door slightly to pause the washing.
3. After spray arms have stopped, you can open the door completely.
4. Add
any additional dishes.
5. Close the door.
6. Press the Start/Reset button. Dishwasher will begin to run again in approximately 10
seconds.
At the End of the Wash Cycle
When the dishwasher cycle has completed, the dishwasher will sound an alarm for 8 seconds
and then stop. Turn off your dishwasher by pressing the ON/OFF button, then turn off the water
supply and open the door. Extremely hot dishes are more susceptible to breaking, so wait
approximately 15 minutes before unloading. Dishes will also dry better if given time to properly
cool.
• Turn off the dishwasher.
Check to make sure all indicator lights are off, signaling that the wash cycle has ended.
Turn off your dishwasher by pressing the ON/OFF button.
Turn off tap water.
• Carefully open the door.
Hot dishes are more susceptible to breaking. Allow them to cool for 15 minutes before
removing.
Open the dishwasher door and leave it open to allow cool air to circulate. This will
improve your drying.
• Unload the dishwasher.
It is normal for the dishwasher to remain wet inside after the wash cycle has finished.
WARNING! It is dangerous to open the door while the machine is washing; hot water
has the potential to scald and/or burn.
10