NewAir Portable Dishwasher ADW-2600W - Manual (Page 18)

1. Screw the faucet adapter onto/into your faucet. Check to make sure there are no leaks.
You can use Teflon tape to temporarily eliminate leaks if necessary.
2. Connect the six-sided connection of the drain hose to the drain port on the back of your
dishwasher. Make sure not to damage the threads by over-tightening.
3. Connect the star shaped connection of the inlet hose to the inlet port on the back of the
dishwasher. Make sure not to damage the threads by over tightening.
4. Connect the circular connection of the drain hose to the longer (bottom) male connection
on the quick connect.
5. Connect the circular connection of the inlet hose to the shorter (top) male connection on
the quick connect.
6. To attach the quick connect onto the faucet adapter, pull down on the outer locking collar
of the quick connect while pushing the quick connect upward into the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar.
Check to make sure that the connection is secure.
8. Slowly open the hot water line and check to see if there are any water leaks at the hose
connections. If you see a leak, immediately turn off the water supply and repair the
connection.
Important:
1. Once the water supply is open, even if you close it immediately after, the inlet hose will
become pressurized.
2. To relieve water pressure from inside the inlet hose, first make sure the water line (faucet)
is closed, then press and hold the red pressure relief button on the quick connect until the
water stops flowing.
WARNING
Failure to relieve water pressure before disconnecting the quick-connect from the faucet
will result in back-pressure and over-spray. This water can be very hot and can
potentially cause severe burns and/or scalding.
DANGER
Do not let children disconnect the dishwasher. Closely supervise all children near the
dishwasher.
Note:
Hard water conditions will negatively affect your dishwasher’s washing performance. Hard
water can also contribute to a white filmy substance, also known as “lime,” on the stainless steel
surface of the dishwasher tub and heating element. To minimize the buildup of lime,
periodically run the dishwasher empty with 1 cup of white vinegar. For optimal results, do this
on a weekly basis.
To Disconnect your Dishwasher
1. Completely shut off the water supply at the faucet.
2.
Unplug the electrical cord from the outlet.
STARTING THE DISHWASHER
Before starting your dishwasher, you should check to make sure:
1. The dishwasher is level
2. The inlet valve is open
3. None of the connections are leaking
4. All wires are tightly connected
5. Power is turned on
6. The inlet and drain hoses are not knotted
7.
Remove all packing materials and printed inserts from inside the dishwasher.
Attention: After installation, keep this manual for easy reference. The contents will be very
helpful for ensuring optimal performance.
16