AT&T CL81211 - Manual (Page 10)

Getting started
5
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see
Installation options on page 8 for details.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
www.telephones.att.com
or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
2. The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
Plug the power adapter into an electrical outlet
not controlled by a wall switch.
Charger installation
Telephone base installation
Raise the antenna.
•
Plug the other end
of the telephone line
cord into the telephone
jack on the back of the
telephone base.
•
Route the power
adapter cord and the
telephone line cord
through these slots.
•
Plug the small end of the telephone base power adapter into
the power adapter jack on the back of the telephone base.
•
Plug the large end of
the power adapter into
a power outlet not
controlled by a
wall switch.
•
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
•
If you have DSL high-
speed Internet service, a
DSL filter (not included)
is required.
Telephone
line cord