Samsung SC-D5000-XAC - Manual (Page 28)

ENGLISH
28 28
The Camcorder : Preparation
Using the Lithium Ion Battery Pack
1. Attach the Battery Pack to the device.
2. Connect the AC Power Adapter to the AC Power Cord and connect the AC Power Cord to a
wall outlet.
3. Connect the DC cable to the DC jack on the device.
4. Turn the device off and the charging indicator will start to flash, showing that the battery is
charging.
5. When the battery is fully charged, disconnect the battery pack
and the AC Power Adapter from the device.
✤ The amount of continuous recording time available depends on:
- The type and capacity of the battery pack you are using.
- How often the Zoom / flash is used.
- Type of use (Camcorder/Camera/With LCD monitor etc.).
- Ambient temperature.
It is recommended to have additional battery packs available.
✤ Even when the power switched off, the battery pack will still discharge if it is left attached to the device.
✤ The Battery Pack may be charged a little at the time of purchase.
✤ Fully discharging the Lithium battery pack is not required since there is no memory effect.
✤ For prolonged use of the Battery Pack, remove the Battery Pack from the camcorder after use/charging.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90 ~ 100%
On for a second and off Error - Reset the battery pack and the
for another second DC cable
Charging the Lithium Ion Battery Pack
Reference
00779F VPD6050-UK (008-059) 8/16/04 1:40 PM Page 28