Samsung SCH-R420DAAMTR - Manual (Page 80)

77
3. Wait for the beep and say the digits using your normal tone
of voice. After a moment, the phone plays back the
recording and prompts “Did the recording sound ok?”
• If the recording was good, say “Yes.”
• If you need to re-record, say “No.”
If you say “No,” the phone prompts you to pronounce the
digits again. Wait for the beep and then say the digits.
Repeat this step until you’re satisfied with the recording.
4. After confirming that the recording sounds “ok”, continue
the recording process with the next set of digits.
5. After 10 sets of digits, the phone asks whether you want to
do more adaptation. Answer “Yes.”
6. Repeat steps 4 and 5 for another 10 sets of digits. After the
second group of 10 sets of digits, “Adaptation complete”
plays through the speaker and you are returned to the Digit
Dialing menu.
Reset Digits
To reset digit dialing to factory default settings, do the following:
1. In standby mode, press the MENU soft key, then select
Voice SVC ➔ Voice Settings ➔ Digit Dialing ➔ Reset Digits.
The phone prompts you to confirm digit reset.
2. Press OK or to reset your digit adaptation, or press
Back or to cancel.
Sound
Sound lets you specify what (if any) text prompts you want your
phone to read to you through the earpiece.
1. In standby mode, press the MENU soft key, then select
Voice SVC ➔ Voice Settings ➔ Sound. The following options
appear in the display:
• Prompts — On/Off — Enables or disables audio prompts.
• Digits — On/Off — Enables or disables digit playback.
• Names — On/Off — Enables or disables name playback.
• Name Settings — Lets you adjust the Speed (Faster or Slower)
and Volume (Louder or Softer) of your phone’s audio name
playback.
2. Select the desired option, then highlight the desired
setting.
3. Press OK or to accept the new setting. Press to
discard the new setting and return to the Voice Settings
menu.