Samsung HW-D650S-ZA - Manual (Page 58)

58
English
Other Information
Symptom Check Remedy
Can't select Dolby Pro
Logic llx mode. • Is the input signal selected
properly?
• Only 2 channel signal can
select Dolby Pro Logic IIx
mode. (ex:Dolby Digital, PCM,
2 channel analog input signal.)
Can't select NEO:6
mode. • Is the input signal selected
properly?
• Use PCM and Analog input
signal.
There is no sound
when playing a DTS
encoded DVD. • Is Digital input selected? • Check whether the DVD player
is properly connected and refer
to page 30 to select the digital
input.
Product Protection Function
Heat protection
The protection function will come on if the main unit or power transformer overheats.
" " will appear in the display .
This function will come on :
- If speaker terminal is shorted
- If speaker cable is shorted
If there is no problem when you turn the unit on again after turning it off, PROTECTION mark will
disappear on the display and the unit will work properly.
Auto Calibration Error List
Error No. Auto Calibration Error Message on OSD
E02 NO MIC Connect the calibration microphone.
E03 NOISY Keep quiet during the measurement.
E04 MIC LEVL
The speaker are too close to the microphone.
Install all speakers and the calibration microphone at the proper location.
E05 NO FRONT Connect the front speaker correctly.
E07 LEVL OVR Install all speakers and the calibration microphone at the proper location.
E08 DIST OVR
Some speakers are too far from calibration microphone.
Install all speakers and the calibration microphone at the proper location.
E13 TIME OVR
Unplug and re-plug the power cable.
Then, perfrom the measurement again.
E14 CODE ERR
Unplug and re-plug the power cable.
Then, perfrom the measurement again.
•
HW-D600_D650S_XAA_0616.indd 58 HW-D600_D650S_XAA_0616.indd 58 2011-06-16 10:28:08 2011-06-16 10:28:08