Samsung SPK4215MX-XAC - Manual (Page 23)

23
Setting up Your Monitor Plug and Play
Our adoption of the new VESA  Plug and Play solution eliminates complicated and time consuming
setup. It allows you to install your monitor in a Plug and Play compatible system without the usual
hassles and confusion. Your PC system can easily identify and configure itself for use with your display.
This monitor automatically tells the PC system its Extended Display Identification (EDID) data using
Display Data Channel (DDC) protocols so the PC system can automatically configure itself to use the flat
panel display. If your PC system needs a video driver, following the instructions given below according
to the operating system your computer uses.
Installing the Video Driver
When prompted by the operating system for the monitor driver, insert the Driver diskette included with
this monitor. Driver installation is slightly different from one operating system to another. Follow the
directions as appropriate for the operating system you have.
Windows 98, Windows Me and Windows 2000
1. Windows_ 98, Windows_ Me and Windows_ 2000 will auto-detect your new monitor and start
the "Add New Hardware Wizard" if the drivers are not already installed. Click the NEXT button
to search for drivers.
2. Check the diskette drive box to install the drivers off the diskette provided with your monitor and
click NEXT.
3. Confirm that Windows found the driver on the diskette and click NEXT again to install the driver.
To manually install or update the driver, follow the directions below:
1. Click on START, SETTINGS, CONTROL PANEL, DISPLAY SETTINGS tab, ADVANCED, MONITOR
tab, CHANGE, This will start the "Add New Hardware Wizard".
2. Follow the same directions as given in the steps in the section above.
Version 4.00.950A
1. Click on START, SETTINGS, CONTROL PANEL, DISPLAY SETTINGS tab, CHANGE DISPLAY TYPE,
CHANGE, HAVE DISK.
2. Type the diskette drive letter in the box and click OK.
Version 4.00.950B
1. Click on START, SETTINGS, CONTROL PANEL, DISPLAY, ADVANCED PROPERTIES, MONITOR tab,
HAVE DISK.
2. Type the diskette letter in the box and click OK
AA68-01689A-2 4/12/05 10:49 AM Page 23