AT&T 1722 - Manual (Page 3)

2
Feature Setup
1 To enter Feature Setup mode, press and
hold
S until the system announces
“N
UMBER OF RINGS IS
…”
2 Press and release
S until the
system announces the feature you
want to set.
3 Press and release a or
r
until the system
announces the setting you want.
Refer to the Feature Summary
for options.
4 Press and release
S to set
up the next feature listed on the
Feature Summary
— OR —
Press and release
P to
exit Feature Setup.
The new settings will be saved.
5 After you have selected the feature
options, you can review the settings
by pressing and releasing
S.
FEATURE SETUP
When any feature is on, the Message Window displays
When any feature is off, the Message Window displays
Feature Summary
FEATURE: SYSTEM OPTIONS:
ANNOUNCES:
RING SELECT “N
UMBER OF
Choose how many times the line will
RINGS IS
...” ring before the system answers a call.
• Set for 2 to 7 rings, or choose
Toll Saver 2/4 or Toll Saver 4/6.
• When set to Toll Saver 2/4, the system
answers after four rings when you have
no new messages and after two rings
when you do. Toll Saver 4/6 causes the
system to answer after six rings when
you have no new messages and after
four rings when you do.
• During setup, the Message Window will
display the number of rings, (8 for Toll
Saver 2/4, or 9 for Toll Saver 4/6).
REMOTE “R
EMOTE ACCESS
Change the Remote Access Code to
ACCESS CODE
CODE IS
...” any three-digit number from 500 to 999.
• The Remote Access Code, preset to 500,
allows you to access many features of this
answering system remotely from a touch
tone phone.
• The system will prompt you to repeat
Steps 2 and 3 of Feature Setup until
you have set all three digits.