AT&T 1722 - Manual (Page 4)

3
Feature Summary continued
FEATURE: SYSTEM OPTIONS:
ANNOUNCES:
ANNOUNCEMENT “A
NNOUNCEMENT
Choose ON to hear the announcement
MONITOR
MONITOR IS
...” when your system answers a call. Choose
OFF to have it silent on your end. (Your
caller will still hear the announcement.)
NOTE: Volume must be set to a
level you can hear to use
Announcement Monitor.
NUMBER “N UMBER When this feature is on, the system will
ANNOUNCE ANNOUNCE IS ...” announce the caller’s telephone number
(Please see between the second and third rings.
NOTE below.)
NOTE: When the Number Announce
feature is on and Ring Select is set for
two rings, the unit will answer after
three rings to allow enough time for
the system to announce the caller’s
telephone number.
STORE NUMBER “S TORE NUMBER IS ...” When this feature is on, the system
(Please see announces the caller’s telephone
NOTE below.) number when it plays back a message.
ACCEPT “A
CCEPT BLOCKED
Choose ON to have the system accept
BLOCKED CALLS
CALLS IS
...” all calls. Choose OFF to have the system
(Please see respond to “blocked” calls with the
NOTE below.) pre-recorded announcement, “W E ’ RE SORRY ,
BLOCKED CALLS TO THIS NUMBER CANNOT BE
ACCEPTED ,” and hang up without recording
a message.
AUDIBLE “M
ESSAGE ALERT IS
...” When this feature is on, the system beeps
MESSAGE ALERT every 15 seconds when you have new
messages.
NOTE: For this feature to work, you must subscribe to Caller Identification service from
your telephone service provider. There is a fee for this service, and it may not be available
in all areas.
FEATURE SETUP