Samsung HPR8082X-XAA - Manual (Page 12)

¸ SLEEP button
Press to select a preset time interval for automatic shutoff.
˛ SRS button
Selects Trusurround XT mode.
◊ AUTO button
Press to reset automatically screen quality and position in PC
mode.
± P.SIZE button
Select Picture size. (Refer to page 40)
≠ PIP control buttons
PIP: Activates picture in picture. (Refer to page 42)
Size: Press to make the PIP window Large, Small or Double.
Swap: Exchanges the video signal that is currently displayed on
the main screen with the signal in the PIP window.
Source: Press to select one of the available signal sources for the
PIP window.
– SET button
Used during set up of this Samsung remote control, so that it will
work compatibly with other devices (VCR, Cable Box and DVD).
— DNIe button
Activates DNIe Demo. (Refer to page 39)
÷ E.SAVING button
Press to adjust screen brightness according to surrounding
environment. (Refer to page 82)
® VCR, DVD control buttons
Controls VCR tape or DVD disc functions: Stop, Rewind,
Play/Pause, and Fast Forward.
∑ RESET button
If your remote control is not functioning properly, take out the
batteries and press the reset button for about 2~3 seconds.
Re-insert the batteries and try using the remote control again.
12
Installing the Batteries in Your Remote Control
1
Slide the back cover to
open the battery
compartment of the remote
control
.
3
Slide the cover back into
place.
2
Install two AAA size batteries.
Make sure to match the “+” and
“-” ends of the batteries with the
diagram inside the compartment.
• Do not mix battery types, i.e.
alkaline and manganese.
Remote Control Operation Range
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the PDP Monitor’s remote control receiver.
BN68-00852B-00Eng(002~025) 11/22/05 1:45 PM Page 12