Samsung FE710DRS-XAA - Manual (Page 19)

SURF
A
CE COOKING
Surface cooking _19
Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
1
6
5 2
3 4
1. Single element: Left rear
2. Single element: Right rear
3. Dual element: Left front (3,000W)
4. Triple element: Right front (3,000W)
5. Warming center: Center rear
6. Hot surface indicator
Hot surface indicator
• Comes on when the unit is turned on or hot to the touch.
• Stays on even after the unit is turned off.
• Glows until the unit is cooled to approximately 150 °F.
Cooking areas
• The cooking areas on your range are identified by permanent circles on the glass cooking
surface. For the most efficient cooking, fit the pan size to the element size.
• Pans should not extend more than ½˝ to 1˝ beyond the cooking area.
• When a control is turned on, you can see a glow through the glass cooking surface. The
element will cycle on and off to maintain the preset heat setting, even at high settings.
• For more information on selecting proper types of cookware, refer to the section “Using the
proper cookware” on page 23.
FE710DRS_XAA_DG68-00333A-07.indd 19 31/10/2012 17:31:09