Samsung SCH-R220ZSADYN - Manual (Page 84)

He
alth
and Saf
ety
He
alth
and Saf
ety
Health and Safety 157 156 Health and Safety
Use of other accessories may not ensure compliance with FCC RF exposure
guidelines. The FCC has granted an Equipment Authorization for this mobile
phone with all reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines. The maximum SAR values for this model phone as reported
to the FCC are:
Head: 0.40 W/Kg.
Body-worn: 0.42 W/Kg.
SAR information on this and other model phones can be accessed online on the
FCC’s website through http://transition.fcc.gov/oet/rfsafety/sar.html. To find
information that pertains to a particular model phone, this site uses the phone
FCC ID number which is usually printed somewhere on the case of the phone.
Sometimes it may be necessary to remove the battery pack to find the number.
Once you have the FCC ID number for a particular phone, follow the instructions
on the website and it should provide values for typical or maximum SAR for a
particular phone. Additional SAR information can also be obtained at http://
www.fcc.gov/encyclopedia/specific-absorption-rate-sar-cellular-telephones.
FCC Part 15 Information to User:
Pursuant to part 15.21 of the FCC Rules, you are cautioned that changes or
modifications not expressly approved by Samsung could void your authority to
operate the device.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,