AT&T E2912B - Manual (Page 3)

Installation and setup
7. Plug the large end
of the smaller power
adapter into an electrical
outlet not controlled by a
wall switch.
You may be able to
make and receive short
calls. For best perform-
ance, place the handset
in the telephone base
or charger to charge for
at least 16 hours before
first use.
NOTES:
1. Use only the power adapter supplied with this product, or equiv-
alent. To order a replacement power adapter, visit our
website at
www.telephones.att.com
, or call
1 (800) 222-3111
. In Canada dial
1 (866)
288-4268
.
2. Be sure to use an electrical outlet not controlled by a wall
switch.
3. This power unit is intended to be correctly oriented in a
vertical or floor mount position. The prongs are not designed
to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
4. If you receive high speed internet through your telephone
line (commonly referred to as DSL), and you are experiencing
interference during telephone conversations and/or your caller
ID features are not functioning properly, install a DSL filter
to the telephone line between the telephone base and the
telephone wall jack. Contact your DSL service provider for a
DSL filter.
TONE
MUTE
DELETE
INT REDIAL
PAUSE
FLASH CLEAR
Telephone line cord
DSL filter
(Optional for DSL users,
see number four in the
note section below.)
1
2
3
4 5
6
7
1. Plug one end of the telephone line
cord into the telephone jack at the bot-
tom of the telephone base.
2. Plug the small end of the larger
power adapter into the power jack at
the bottom of the telephone base.
3. Route cords through slots.
4. Plug the large end of the larger
power adapter into an electrical out-
let not controlled by a wall switch.
5. Plug the other end of the telephone
line cord into a telephone wall jack.
6. Plug the small end of the smaller
power adapter into the jack on the under-
side of the charger, then route the cord
through the slot as shown.
2