AT&T 2256 User Manual
AT&T Handset Cordless Phone
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- CONTENTS
- BEFORE YOU BEGIN
- INSTALLATION
- Charging Stand Installation
- Table/Desk Installation
- Belt Clip
- Headset
- Wall Installation
- 1. Press the tabs as indicated
- 2. Flip the base extension open
- 3. Run the line cord and the power cord through the opening
- 4. Connect the telephone line cord
- 5. Connect the power cord
- 6. Snap the base extension down firmly
- 7. Mount the base on the wall
- 8. Follow Steps 3–5 in “Table/Desk Installation.”
- TELEPHONE FEATURE SETUP
- TELEPHONE OPERATION
- INTERCOM OPERATION
- PHONEBOOK
- CALLER ID OPERATION
- ANSWERING SYSTEM OPERATION
- REMOTE ACCESS
- BATTERIES
- IN CASE OF DIFFICULTY
- TELEPHONE OPERATION
- If the phone does not work at all, check these items first:
- If you have no dial tone:
- If you hear a triple-beep signal when you try to use the handset:
- If you hear noise or interference when using the phone:
- If the phone does not ring when you receive a call:
- If your telephone misdials:
- If you are unable to operate special telephone services or other equipment requiring touch tone signals:
- CALLER ID
- ANSWERING SYSTEM
- TELEPHONE OPERATION
- DEFAULT SETTINGS
- TECHNICAL SPECIFICATIONS
- INDEX
- IMAGES